spacepaste

Paste details

reply | raw

  1.  
  2. Wiphy phy0
  3. max # scan SSIDs: 4
  4. max scan IEs length: 2257 bytes
  5. max # sched scan SSIDs: 0
  6. max # match sets: 0
  7. max # scan plans: 1
  8. max scan plan interval: -1
  9. max scan plan iterations: 0
  10. Retry short limit: 7
  11. Retry long limit: 4
  12. Coverage class: 0 (up to 0m)
  13. Device supports RSN-IBSS.
  14. Device supports AP-side u-APSD.
  15. Device supports T-DLS.
  16. Supported Ciphers:
  17. * WEP40 (00-0f-ac:1)
  18. * WEP104 (00-0f-ac:5)
  19. * TKIP (00-0f-ac:2)
  20. * CCMP-128 (00-0f-ac:4)
  21. * CCMP-256 (00-0f-ac:10)
  22. * GCMP-128 (00-0f-ac:8)
  23. * GCMP-256 (00-0f-ac:9)
  24. * CMAC (00-0f-ac:6)
  25. * CMAC-256 (00-0f-ac:13)
  26. * GMAC-128 (00-0f-ac:11)
  27. * GMAC-256 (00-0f-ac:12)
  28. Available Antennas: TX 0x3 RX 0x3
  29. Configured Antennas: TX 0x3 RX 0x3
  30. Supported interface modes:
  31. * IBSS
  32. * managed
  33. * AP
  34. * AP/VLAN
  35. * monitor
  36. * P2P-client
  37. * P2P-GO
  38. * outside context of a BSS
  39. Band 1:
  40. Capabilities: 0x11ef
  41. RX LDPC
  42. HT20/HT40
  43. SM Power Save disabled
  44. RX HT20 SGI
  45. RX HT40 SGI
  46. TX STBC
  47. RX STBC 1-stream
  48. Max AMSDU length: 3839 bytes
  49. DSSS/CCK HT40
  50. Maximum RX AMPDU length 65535 bytes (exponent: 0x003)
  51. Minimum RX AMPDU time spacing: 8 usec (0x06)
  52. HT TX/RX MCS rate indexes supported: 0-15
  53. Bitrates (non-HT):
  54. * 1.0 Mbps
  55. * 2.0 Mbps (short preamble supported)
  56. * 5.5 Mbps (short preamble supported)
  57. * 11.0 Mbps (short preamble supported)
  58. * 6.0 Mbps
  59. * 9.0 Mbps
  60. * 12.0 Mbps
  61. * 18.0 Mbps
  62. * 24.0 Mbps
  63. * 36.0 Mbps
  64. * 48.0 Mbps
  65. * 54.0 Mbps
  66. Frequencies:
  67. * 2412 MHz [1] (20.0 dBm)
  68. * 2417 MHz [2] (20.0 dBm)
  69. * 2422 MHz [3] (20.0 dBm)
  70. * 2427 MHz [4] (20.0 dBm)
  71. * 2432 MHz [5] (20.0 dBm)
  72. * 2437 MHz [6] (20.0 dBm)
  73. * 2442 MHz [7] (20.0 dBm)
  74. * 2447 MHz [8] (20.0 dBm)
  75. * 2452 MHz [9] (20.0 dBm)
  76. * 2457 MHz [10] (20.0 dBm)
  77. * 2462 MHz [11] (20.0 dBm)
  78. * 2467 MHz [12] (20.0 dBm)
  79. * 2472 MHz [13] (20.0 dBm)
  80. * 2484 MHz [14] (disabled)
  81. Band 2:
  82. Capabilities: 0x11ef
  83. RX LDPC
  84. HT20/HT40
  85. SM Power Save disabled
  86. RX HT20 SGI
  87. RX HT40 SGI
  88. TX STBC
  89. RX STBC 1-stream
  90. Max AMSDU length: 3839 bytes
  91. DSSS/CCK HT40
  92. Maximum RX AMPDU length 65535 bytes (exponent: 0x003)
  93. Minimum RX AMPDU time spacing: 8 usec (0x06)
  94. HT TX/RX MCS rate indexes supported: 0-15
  95. Bitrates (non-HT):
  96. * 6.0 Mbps
  97. * 9.0 Mbps
  98. * 12.0 Mbps
  99. * 18.0 Mbps
  100. * 24.0 Mbps
  101. * 36.0 Mbps
  102. * 48.0 Mbps
  103. * 54.0 Mbps
  104. Frequencies:
  105. * 5180 MHz [36] (20.0 dBm)
  106. * 5200 MHz [40] (20.0 dBm)
  107. * 5220 MHz [44] (20.0 dBm)
  108. * 5240 MHz [48] (20.0 dBm)
  109. * 5260 MHz [52] (20.0 dBm) (no IR, radar detection)
  110. * 5280 MHz [56] (20.0 dBm) (no IR, radar detection)
  111. * 5300 MHz [60] (20.0 dBm) (no IR, radar detection)
  112. * 5320 MHz [64] (20.0 dBm) (no IR, radar detection)
  113. * 5500 MHz [100] (27.0 dBm) (no IR, radar detection)
  114. * 5520 MHz [104] (27.0 dBm) (no IR, radar detection)
  115. * 5540 MHz [108] (27.0 dBm) (no IR, radar detection)
  116. * 5560 MHz [112] (27.0 dBm) (no IR, radar detection)
  117. * 5580 MHz [116] (27.0 dBm) (no IR, radar detection)
  118. * 5600 MHz [120] (27.0 dBm) (no IR, radar detection)
  119. * 5620 MHz [124] (27.0 dBm) (no IR, radar detection)
  120. * 5640 MHz [128] (27.0 dBm) (no IR, radar detection)
  121. * 5660 MHz [132] (27.0 dBm) (no IR, radar detection)
  122. * 5680 MHz [136] (27.0 dBm) (no IR, radar detection)
  123. * 5700 MHz [140] (27.0 dBm) (no IR, radar detection)
  124. * 5745 MHz [149] (disabled)
  125. * 5765 MHz [153] (disabled)
  126. * 5785 MHz [157] (disabled)
  127. * 5805 MHz [161] (disabled)
  128. * 5825 MHz [165] (disabled)
  129. Supported commands:
  130. * new_interface
  131. * set_interface
  132. * new_key
  133. * start_ap
  134. * new_station
  135. * set_bss
  136. * authenticate
  137. * associate
  138. * deauthenticate
  139. * disassociate
  140. * join_ibss
  141. * remain_on_channel
  142. * set_tx_bitrate_mask
  143. * frame
  144. * frame_wait_cancel
  145. * set_wiphy_netns
  146. * set_channel
  147. * set_wds_peer
  148. * tdls_mgmt
  149. * tdls_oper
  150. * probe_client
  151. * set_noack_map
  152. * register_beacons
  153. * start_p2p_device
  154. * set_mcast_rate
  155. * connect
  156. * disconnect
  157. * channel_switch
  158. * set_qos_map
  159. * Unknown command (121)
  160. Supported TX frame types:
  161. * IBSS: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
  162. * managed: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
  163. * AP: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
  164. * AP/VLAN: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
  165. * mesh point: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
  166. * P2P-client: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
  167. * P2P-GO: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
  168. * P2P-device: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
  169. Supported RX frame types:
  170. * IBSS: 0x40 0xb0 0xc0 0xd0
  171. * managed: 0x40 0xd0
  172. * AP: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0
  173. * AP/VLAN: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0
  174. * mesh point: 0xb0 0xc0 0xd0
  175. * P2P-client: 0x40 0xd0
  176. * P2P-GO: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0
  177. * P2P-device: 0x40 0xd0
  178. software interface modes (can always be added):
  179. * AP/VLAN
  180. * monitor
  181. valid interface combinations:
  182. * #{ managed } <= 2048, #{ AP } <= 8, #{ P2P-client, P2P-GO } <= 1,
  183. total <= 2048, #channels <= 1, STA/AP BI must match, radar detect widths: { 20 MHz (no HT), 20 MHz, 40 MHz }
  185. HT Capability overrides:
  186. * MCS: ff ff ff ff ff ff ff ff ff ff
  187. * maximum A-MSDU length
  188. * supported channel width
  189. * short GI for 40 MHz
  190. * max A-MPDU length exponent
  191. * min MPDU start spacing
  192. Device supports TX status socket option.
  193. Device supports HT-IBSS.
  194. Device supports SAE with AUTHENTICATE command
  195. Device supports low priority scan.
  196. Device supports scan flush.
  197. Device supports AP scan.
  198. Device supports per-vif TX power setting
  199. P2P GO supports CT window setting
  200. Driver supports full state transitions for AP/GO clients
  201. Driver supports a userspace MPM
  202. Device supports active monitor (which will ACK incoming frames)
  203. Driver/device bandwidth changes during BSS lifetime (AP/GO mode)
  204. Device supports configuring vdev MAC-addr on create.
  205.  
Powered by spacepaste. Paste removal.